Smartek-systems SVS-1 User Guide-Part B Manuel d'utilisateur télécharger pdf (Page 25)

Scenario 5 Set Output Relays

Select Detector Interface and Route Relays:

1) Click the Detector Interface button to select the

type of detector/controller interface to be used (

BIU #1 Card File ).

2) Click the Ph- button to select Phase group 3L.

Note that the line zones corresponding to the

selected phase group turn green. All others are

magenta.

3) Click the RI/Card= button to select the number

of relays per card = 2 . Click the RI Slot= to select

the card file slot used= 2.

4) After selecting the RI/Card=2 and the RI Slot=2,

the number detector channels (D1, D2, etc.) that

are shown changes corresponding to this selection.

5) Click the Ext= and the Dly= to select the

Detection Extension in seconds and the Detection

Delay in seconds.

6) Click N, Or, And button to select logic for

combining (N=Not Used) Phase Groups into

Detector Channels.

7) To clear the settings for the selected Phase

group or for all Phase groups click the Clear or the

Clear All button.

BIU #1 Card file Detector/Controller Interface with 2 Relays per SVS-1 card, Slot 2 used, and 3 Phases (Line Zone Groups)

Phase 3L, Detection Delay=0 sec, Detection Extension=0, Route to Detector Channel D1

Phase 8T, Detection Delay=0 sec, Detection Extension=0, Route to Detector Channel D2

Phase 8R, Detection Delay=2 sec, Detection Extension=2, Route to Detector Channel D2

Specifies Routing to Onboard Output Relay

Connector (1, 2, .., 10 0-Disables) for shelf

mount SVS-1

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 44 45

Pas de commentaire

Smartek-systems SVS-1 User Guide-Part B Manuel d'utilisateur Page 25